Questions about this plan? Visit today or call 1-800-913-2350

View this plan at

Plan 930-510

6299 sq/ft,
4 beds,
4.5 baths,
144' wide,
112' 4" deep


Plan Set
Wood 2x6
Additional Construction Sets
Each Additional Set
Audio Video Design

House Features

Main Floor Bedrooms
Main Floor Master Bedroom
Split Bedrooms
Walk In Closet
Breakfast Nook
Butler's Pantry
Eating Bar
Kitchen Island
Walk In Pantry Cabinet Pantry
Den Office Study Computer
Family Room Keeping Room
Main Floor Laundry
Master Sitting Area
Wet Bar
Wine Cellar
Oversized Garage
Rear Entry Garage
Side Entry Garage
Suited For Corner Lot
Suited For View Lot
Covered Front Porch
Covered Rear Porch
Outdoor Kitchen Grill
Additional Half Bath
Unusual Shape

Styles Classifications



1097 sq/ft
Main Floor
6299 sq/ft
1696 sq/ft
310 sq/ft
112' 4"
33' 7"
Primary Pitch
Ceiling Details
Ceiling heights vary. The foyer and Grand Salon go up to 23 ft. 8 in. The Dining Room goes up to 26 ft. The Leisure Room and kitchen go up to 15 ft. 6 in. The Master Bath goes to 15 ft. 4 in.
Garage Ceiling
Main Ceiling

Floor Plan - Main Floor

European Floor Plan - Main Floor Plan #930-510
Questions about this plan? Visit today or call 1-800-913-2350

View this plan at

In addition to the house plans you order, you may also need a site plan that shows where the house is going to be located on the property. You might also need beams sized to accommodate roof loads specific to your region. Your home builder can usually help you with this. You may also need a septic design unless your lot is served by a sanitary sewer system. Many areas now have area-specific energy codes that also have to be followed. This normally involves filling out a simple form providing documentation that your house plans are in compliance.

To find out what documents you should expect with your house plans, see

In some regions, there is a second step you will need to take to insure your house plans are in compliance with local codes. Some areas of North America have very strict engineering requirements. Examples of this would be earthquake-prone areas of California and the Pacific Coast, hurricane risk areas of the Florida, Gulf & Carolina Coasts. New York, New Jersey, Nevada, and parts of Illinois require review by a local professional as well. If you are building in these areas, it is most likely you will need to hire a state licensed structural engineer to analyze the design and provide additional drawings and calculations required by your building department. If you aren’t sure, building departments typically have a handout they will give you listing all of the items they require to submit for and obtain a building permit.

Additionally, stock plans do not have a professional stamp attached. If your building department requires one, they will only accept a stamp from a professional licensed in the state where you plan to build. In this case, you will need to take your house plans to a local engineer or architect for review and stamping. In addition, plans which are used to construct homes in Nevada are required to be drawn by a licensed Nevada architect.

Note: All sales on house plans are final. No refunds or exchanges can be given once your order has been fulfilled or once we have begun to customize a home plan to your specifications.